blitz

06-24-2012, 07:12 PM

When I import jewelry into bunkspeed (which is natively using a meter as the unit), my original models use a scale in mm. So as I import and deselect "auto scale", models which are usually around 20mm wide become 20 meters wide in bunkspeed pro. To correct this, I scale the model down by a factor of 0.001. Doing so correctly scales the model to its proper size in the bunkspeed project however, the scale transform is limited to 2 decimal places. So even though my model is still scaled properly after the transform operation, the transform shows a scale adjustment of 0.01 instead of 0.001.

Can you increase the visible number of decimal places on the scale transform to at least 3 decimal places?

Thanks!

Can you increase the visible number of decimal places on the scale transform to at least 3 decimal places?

Thanks!